To utilize resisted loads higher than 20 kg and assisted loads higher than 30 kg you will need to attach a pulley between the machine and the athlete. The pulley will double the maximum allowed load at the cost of half the maximum allowed speed (down from 14m/s to 7m/s when using the pulley).
To get the correct data you also need to put the 1080 Software in Second
Gear mode.
The 1080 Sprint 2 system comes with a plastic pulley as standard.
-
Press the gear pulley in the resistance bar and select Pulley.
-
Place the Sprint-line inside the pulley, around the drum
***Make sure the line is correctly aligned in the center of the drum. If it ends up off the drum, there is a high risk of the line cutting due to high friction
- Attach the carabiner/end of the line to the attachment pull slider below the line nozzle and between the front two wheels.
NOTE: Maximum Speed Limit after Gear 2 is attached is 7 m/s.