1. Clear the drum by removing the entire line.

2. Align the line guide-feeder a few millimetres to the right of the left side of the drum
   (facing down and front). If you have to align it by hand, we recommend entering a very
   low load in the software and manually rotate the drum into the correct position.

3. Enter the new line through the line guide-feeder.

4. Enter the line through the hole in the drum

5. Tie a knot at the end of the line

6. Use the calibration feature in the software to wind on the line.
   Note: Leave 10-15mm of gap between the line and the end of the drum – to not risk the
   line tangling at the end of the drum.