Pulley Gear 2 Set up

  • Published on Feb 4, 2026
  • 1 minute(s) read
  • AR
 Prev Next

To utilize resisted loads higher than 50 kg and assisted loads higher than 75 kg you will need to attach a pulley between the machine and the athlete. The pulley will double the maximum allowed load at the cost of half the maximum allowed speed (down from 5 m/s to 2.5 m/s when using the pulley).

To get the correct data you also need to put the 1080 Software in Second
Gear mode.
cable pulley control app.png

pulley cable.png

The 1080 Cable system comes with a solid, ball-bearing pulley.

  1. Press the gear pulley in the resistance bar and select Pulley.

  2. Place the Cable-line inside the pulley, around the drum

***Make sure the line is correctly aligned in the center of the drum. If it ends up off the drum, there is a high risk of the line cutting due to high friction

  1. Attach the carabiner/end of the line to the attachment pull slider.

NOTE: Maximum Speed Limit after Gear 2 is attached is 2.5 m/s.