---
title: "How to Change Line on Sprint 1"
slug: "how-to-change-line-sprint-1"
updated: 2024-12-10T14:37:51Z
published: 2024-12-10T14:37:51Z
canonical: "docs.1080motion.com/how-to-change-line-sprint-1"
---

> ## Documentation Index
> Fetch the complete documentation index at: https://docs.1080motion.com/llms.txt
> Use this file to discover all available pages before exploring further.

# How to Change Line on Sprint 1

![sprint2 open.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint2%20open.jpg)

1. Clear the drum by removing the entire line.

![sprint align.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint%20align.jpg)

1. Align the line guide-feeder a few millimetres to the right of the left side of the drum  

(facing down and front). If you have to align it by hand, we recommend entering a very  

low load in the software and manually rotate the drum into the correct position.

![sprint1 line.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint1%20line.jpg)

1. Enter the new line through the line guide-feeder.

![sprint 2 line insert.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint%202%20line%20insert.jpg)

1. Enter the line through the hole in the drum

![sprint 1 knot.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint%201%20knot.jpg)

1. Tie a knot at the end of the line

![sprint 1 end.jpg](https://cdn.document360.io/2720a32a-6d48-40c3-870e-0cf3536ac843/Images/Documentation/sprint%201%20end.jpg)

1. Use the calibration feature in the software to wind on the line.  

**Note:** Leave 10-15mm of gap between the line and the end of the drum – to not risk the  

line tangling at the end of the drum.